#ADVANCED MCE REMOTE MAPPER TOOL LOAD MC SERIAL#
#ADVANCED MCE REMOTE MAPPER TOOL LOAD MC UPDATE#

(rpm_callback) from (rpm_resume+0x3f4/0圆9c) (pm_generic_runtime_resume) from (_rpm_callback+0x124/0x26c) (cppi41_runtime_resume) from (pm_generic_runtime_resume+0x34/0x40) (dump_backtrace) from (show_stack+0x18/0x1c) Hardware name: Generic AM33XX (Flattened Device Tree) Modules linked in: 8021q bridge stp llc xt_tcpudp iptable_nat nf_conntrack_ipv4 nf_defrag_ipv4 nf_nat_ipv4 xt_REDIRECT nf_nat_redirect nf_nat nf_conntrack iptable_filter ip_tables x_tables arc4 rt2800usb rt2x00usb rt2800lib rt2x00lib crc_ccitt mac80211 cfg80211 pru_rproc pruss_intc musb_dsps musb_hdrc usbcore phy_am335x phy_generic phy_am335x_control usb_common ti_am335x_adc omap_aes_driver pm33xx wkup_m3_ipc wkup_m3_rproc crypto_engine omap_sham pruss_soc_bus ti_emif_sram musb_am335x rtc_omap ir_lan_bbb omap_wdt ti_am335x_tscadc at24 pruss remoteproc WARNING: CPU: 0 PID: 4 at /home/teamcity/buildAgent/work/ee889e486c4390d4/poky/build/tmp/work-shared/webtegriti/kernel-source/drivers/dma/cppi41.c:466 cppi41_run_queue+0x100/0x10c done.Ĭrond: crond (busybox 1.24.1) started, log level 8 Starting Busybox Periodic Command Scheduler: crond. Starting advanced power management daemon: No APM support in kernel ieee80211 phy0: rt2x00lib_request_firmware: Info - Firmware detected - version: 0.36 ieee80211 phy0: rt2x00lib_request_firmware: Info - Loading firmware file 'rt2870.bin' 8021q: adding VLAN 0 to HW filter on device eth0 Starting Dropbear SSH server: 8021q: 802.1Q VLAN Support v1.8

#ADVANCED MCE REMOTE MAPPER TOOL LOAD MC UPDATE#

Update your scripts to load br_netfilter if you need this. bridge: filtering via arp/ip/ip6tables is no longer available by default. Starting Inner Range user reset button: cpsw 4a100000.ethernet eth0: Link is Up - 100Mbps/Full - flow control rx/tx

#ADVANCED MCE REMOTE MAPPER TOOL LOAD MC SERIAL#

Here is a serial debug console sample output: I've noticed that if it boots with the Wi-Fi device plugged in, about 50% of the time, just after the Wi-Fi initialises, I get an error from cppi41.c about a 'Unable to handle kernel NULL pointer dereference at virtual address 00000104'.

Recently I've been updating it to a 4.9.x kernel. The system has been working for a while with 3.14.x and 4.4.x kernels. The system optionally supports a USB Wi-Fi dongle based on the RT2800 chipset (with RT chipset 5390, rev 0502, and with RF chipset 5370 - e.g. I am doing development for a BeagleBone Black based system, built with Yocto morty using linux-ti-staging from meta-mono (kernel 4.9.63-ge30fbd4352).

Advanced mce remote mapper tool load mc